The NOCO Boost Plus Isn’t a Battery Charger—and That Mistake Cost My Shop $3,900
The message came in at 6:47 a.m. from the Take 5 car wash in Findlay, Ohio.
“Still won’t start,” the customer wrote. “I used the NOCO Boost Plus you sold me. It fired right up. I drove ten minutes. Shut it off to grab coffee. Now it’s just clicking.”
The truck was a Ford Maverick. Four months old—the same one we’d bolted a skid plate on before the weather turned. Nothing exotic. Just a newer vehicle with a battery that kept dying, and a shop owner (me) who had sold him the wrong tool for the actual problem.
A few weeks earlier I had sold him the NOCO Boost Plus and called it done. I never checked why his battery was flat in the first place. That shortcut has cost me roughly $3,900 in wasted budget over the past few years. It’s also why I now keep a battery-diagnosis checklist. So far, it’s caught close to fifty similar mistakes.
The Search Phrase That Gives It Away
People search for the exact phrase “how to use noco boost plus battery charger.” I’m not making fun of anyone who types that. I typed it myself when I was starting out. But the phrase hides a misunderstanding: the NOCO Boost Plus is not a battery charger. It’s a jump starter.
That’s not a marketing nitpick. A jump starter pushes a lot of current for a few seconds, just long enough to crank the engine. A charger—like the NOCO GENIUS10 smart battery charger—feeds a small, controlled current into the battery for hours, so the battery can actually store energy again. Both are battery tools. They are not interchangeable.
Why “Just Jump It” Keeps Failing
Here’s what took me too long to understand: after a deep discharge, a battery doesn’t bounce back just because the engine started. Most starting batteries are designed to live near full. Let one sit below roughly 12 volts and the chemistry turns against you. Sulfate crystals start forming on the plates, and every deep discharge chips away at capacity.
The nasty part is that the damage is invisible. The battery can read 12.6 volts at rest, then drop to nothing the moment the starter engages. That’s what happened in the coffee shop parking lot. The Boost Plus did its job—it started the engine. It didn’t do the job nobody asked it to do: put the energy back into the battery.
We also overestimate the alternator. An alternator is designed to power the vehicle and keep a charged battery topped up. It isn’t designed to rescue a deeply discharged battery during a ten-minute drive. With headlights, wipers, heated seats and a radio all pulling power, the battery gets whatever is left over. So the cycle repeats: jump it, drive a few miles, park it, find it dead again.
And then there’s the cause nobody checks first: something is draining the battery while the vehicle sits. This is where aftermarket electronics are the usual suspect. I can’t tell you how many customers ask “what is SWC input on a car stereo?” during an install. SWC stands for steering wheel control—the input connects to the adapter that keeps the steering wheel buttons working with a new stereo.
The question sounds harmless, but the install can cause real trouble. Wire the stereo or its amp to the wrong always-on circuit and the system never fully sleeps. A steady 0.2-amp draw doesn’t seem like much. On a 60Ah battery, that’s an empty battery in about two weeks. Add a dashcam hardwired to the same circuit, and the timeline gets shorter. Now the “dead battery” was never the real problem.
Blaming the battery is easier than finding the drain. That’s exactly where my shortcut started.
What the Shortcut Actually Costs
In early 2023 we started handling batteries and electrical work for a small courier company. Nine vans, all running short city routes. Not a glamorous account—the kind a big shop sometimes waves off because it isn’t worth the paperwork. That attitude never made sense to me. When I was starting out, the suppliers who took my small orders seriously were the ones I stayed with. So I took the account, small or not.
Then the dead-battery calls started. A van wouldn’t crank at the driver’s first stop. The driver would jump it, run the route, park it. Two days later another van did the same thing. We sold them jump boxes. We replaced batteries that failed load tests. Eight batteries over eleven months, plus tow calls, plus my labor, plus a goodwill credit after the owner’s third missed delivery. The total came to just under $3,900.
The frustrating part is that I saw the answer early. I went back and forth on adding a NOCO GENIUS10 smart battery charger to the shop bench—maybe two, so we could rotate vans overnight. It was a no-brainer on paper. But charging a battery isn’t dramatic. Replacing a battery is a visible repair with an invoice attached. I kept choosing the visible repair. Wrong call.
One of my biggest regrets from that period: I didn’t admit the pattern sooner. Three dead batteries in, the pattern was obvious. I still kick myself for letting the fourth and fifth batteries get ordered before I changed the process.
The Fix: One Tool for Starting, One Tool for Charging
You need both tools, because they do different jobs.
If a vehicle won’t start right now, reach for the NOCO Boost Plus. It’s a jump starter. That’s its job, and it does it well.
If the battery keeps dying, won’t hold a charge, or the vehicle sits for days, use the NOCO GENIUS10 smart battery charger. It brings the battery back to full, then maintains it there. It’s the step that actually breaks the cycle.
How to Use the NOCO Boost Plus Correctly
Since the question keeps coming up, here are the steps we hand to customers:
- Connect the red clamp to the positive (+) battery terminal.
- Connect the black clamp to the negative (–) post, or to a clean, unpainted metal ground on the engine block or chassis.
- Make sure the clamps aren’t touching each other, then start the vehicle.
- Once it’s running, disconnect within a minute or so—black clamp first.
That’s the whole trick. It gets the engine started. It does not refill a dead battery, and it does not cure a drain. If the battery is old, damaged, or being drained overnight, you’ll need the other tool for that.
How the GENIUS10 Smart Battery Charger Fits In
Hook it up, plug it in, walk away. A smart charger drops its output as the battery fills and shifts to a maintain mode when it’s full, so leaving it connected overnight is fine. If the battery still starts and holds voltage the next day, you just saved yourself a battery sale. If it doesn’t, at least you know the replacement was necessary.
For a shop or a small fleet, one or two of these on the bench pays for itself fast. For a single vehicle owner, it’s the difference between owning a battery and owning a battery problem.
Bottom line: the Boost Plus is for “can’t start.” The GENIUS10 is for “won’t hold a charge.” Mix them up and you’ll keep paying for tow trucks, unnecessary batteries, and customers you don’t want to lose. I paid that tuition so you don’t have to. Roughly $3,900. Learn it cheaper than I did.